This stainless steel wire rope assembly can be made the length you require. You just select the wire diameter and assembly length in metres to suit your needs (max length 30m).

The wire used in this assembly is 1x19. This was selected for its strength. 

End 1: A fully machined swage fork

End 2: Machined fork and swage stud tensioner

This system is especially suitable for:

• Roof Tensioning
• Fabric Canopy Support and Tension Systems
• Bridge Suspension
• Awning and Fixture Hangers

System lengths up to 30 metres are available.




All measurements in mm

ADJUSTMENT

The tensioner is threaded left hand one end and right hand the other. +/- adjustment is achieved by rotation of the tensioner body in a clockwise/anti-clockwise direction. 

LOCKING

Once adjusted the tensioner is locked in place using the hex nuts on the swage stud end. 

PINS

Clevis pins are locked with split pins which are supplied as standard at both ends. 

READY TO INSTALL

Wire rope assembly systems are supplied ready to install. The tensioner is set to mid point which allows equal adjustment in and out (+/-).
 

CLICK HERE FOR MORE INFORMATION ABOUT OUR DINGFENG WIRE ROPE ASSEMBLIES