HOME
PRODUCTSFORK TO FORK SYSTEM M6 - M36
Description
A fully machined tie rod fork or clevis, with sleek geometry and a wide range of adjustment, developed to meet the requirements of modern Architectural design.
System lengths up to 6 metres are available, rod connectors can be used to achieve longer spans.
Please get in touch for lengths over 3 metres.
Your system length is measured in metres from pin centre to pin centre.
The table below gives technical data to help select the rod diameter and fork dimensions for your fixing points.
All measurements are in mm.
All measurements are in mm.
Finish Options
Fork ends and conical nuts are available with
satin (240 grit) finish as standard.
Highly polished finish is optional.
 240 Grit |
 Polish |
Adjustment
Tie rods and fittings are threaded left hand one end and right hand the other. +/- adjustment is achieved by rotation of the rod in a clockwise/counter clockwise direction.
Locking
Conical locking nuts have been designed to cover Tie bar threads at mid adjustment. Providing a clean line between the rod and end fitting.
Pins
Double headed pins including pin head and locking screw are supplied as standard.
Isolating between different materials, can be achieved by using isolation washers and sleeves.
Ready to Install
Tie Rod systems are supplied ready to install. Fork ends are pre-assembled and adjusted to customer's pin/pin requirements.
Important note about delivery and shipping cost
Please be aware that our lead time can be up to 4 weeks.
Shipping cost may increase depending on your location and total weight of your order. You will be contacted by our sales representative if there are any changes to your shipping cost. This applies to products: F34, F33, RTP System.
You may wish to contact our sales team before confirming your order.
DF FACTORY
Project Center
M.P.：+86.15805265553
M.P.：+86.15805265553
Email：min.sun@df-hardware.com
ADD：Dainan Town, Xinghua City, Jiangsu province,China
